![]() ![]() We recommend using our passivation solution to prevent any surface corrosion from happening more information is available on our Engineering Specifications Page. ![]() NOTE: A small amount of surface corrosion is not uncommon after exposure to weather or salty conditions. MRA Metal Tube Cutter The MRA is a manual tube cutter for stainless steel that uses a patented cutting technique with no electricity required. To polish the cut, follow instructions for maintaining stainless steel surface GF Pipe & Tube Saws Orbitalum, formerly known as GF, best-selling, industry standard high-purity tube saw for cutting high alloy steels and stainless steel process piping. ![]() Be careful not to scratch the tubing while deburring keep the deburr tool straight Note: if necessary, ream/deburr the outside and inside of the tube.Clean the tube using a paper towel and some household cleaner.File any sharp edges evenly with a fine metal file.Immerse the cut end into water to cool the cut tube.Mark cutting point, clamp the tubing in place, and commence the cut.Place duct tape on the clamp of the cut-off saw and to all other areas where the tube will touch the metal to protect the surface from getting scratched while being cut.For round tubing, use 65S Stainless Steel Pipe Cutters.įor demonstration purposes, Inline Design is providing directions based on the use of the cut-off saw.Ĭaution: Wear protective ANSI-approved safety glasses, work gloves, and masks all the time. These saws will leave minimal burr and no heat marks. The saw blades rotate at high speed, are small, inexpensive and available in. Inline Design recommends using a cold saw, band saw, preferably oil-fed. For cutting and beveling stainless pipes, orbital pipe saw is another good choice. These directions will assist the user in properly cutting stainless steel tubes. ![]()
0 Comments
Leave a Reply. |